---

When the main application installation begins you'll be greeted by the SOFTBOX (HDRI) for TurboCAD Setup Wizard (figure 1).

 

figure 1 - Installation Setup Wizard

 

 

 

Pressing the Next button will bring you to the Customer Information Window (figure 2). This is where you will enter the license information that was provided to you at the time of purchase. Enter the information exactly as it was provided. If no Organization information was provided with your license, leave this field blank. Setup will verify the information over the internet at this time. You must have an internet connection and a valid license to proceed with the installation*. If you experience issues with validation please contact support at http://www.dean3.com/contact.

 

* Note: The "Trial Version" does not require a purchased license and will not display this window.

 

figure 2 - Customer Information Window

 

 

 

After your license information has been validated you'll be asked to read and accept the End User License Agreement (EULA) (figure 3).

 

figure 3 - EULA Agreement Window

 

 

 

After accepting the EULA and pressing the Next button, you will see the Setup Type Window (figure 4). Choosing the default, Typical, will tell the installer to install all of the required components for the program to function. Choosing Complete will add any  included extras to the installation and choosing Custom will give you the opportunity to customize the installation when the next window appears. Typical is the recommended setting for most users.

 

figure 4 - Setup Type Window

 

 

After choosing a Setup Type the installer is ready to proceed. (figure 5). Press the Install button to begin the installation process. You will see a Progress Window (figure 6) during the installation and a Confirmation Window (figure 7) when the installation is complete.

 

figure 5 - Ready To Install

 

 

figure 6 - Installation Progress Window

 

 

figure 7 - Installation Complete